Send Message
Home > products > Flash Memory IC Chip > Original Programming IC Chips 256K 32K X 8 5 Volt Only Cmos Flash Memory AT29C256-12JC

Original Programming IC Chips 256K 32K X 8 5 Volt Only Cmos Flash Memory AT29C256-12JC

manufacturer:
Microchip
Description:
FLASH Memory IC 256Kbit Parallel 120 ns 32-PLCC (13.97x11.43)
Category:
Flash Memory IC Chip
Price:
Negotiate
Payment Method:
T/T, Western Union, Paypal
Specifications
Input Load Current:
10 µA (max)
Output Leakage Current:
10 µA (max)
VCC Standby Current CMOS:
300 µA (max)
VCC Standby Current TTL:
3 MA (max)
VCC Active Current:
50 MA (max)
Input Low Voltage:
0.8 V (max)
Input High Voltage:
2.0 V (min)
Output Low Voltage:
0.45 V (max)
Highlight:

integrated circuit ic

,

integrated circuit components

Introduction

 

 

Original Programming IC Chips 256K 32K X 8 5 Volt Only Cmos Flash Memory AT29C256

 

 

256K (32K x 8) 5-volt Only Flash Memory AT29C256

 

 

Features

 

• Fast Read Access Time – 70 ns

• 5-volt Only Reprogramming

• Page Program Operation

  – Single Cycle Reprogram (Erase and Program)

  – Internal Address and Data Latches for 64 Bytes

• Internal Program Control and Timer

• Hardware and Software Data Protection

• Fast Program Cycle Times

  – Page (64 Byte) Program Time – 10 ms

  – Chip Erase Time – 10 ms

• DATA Polling for End of Program Detection

• Low-power Dissipation

  – 50 mA Active Current

  – 300 µA CMOS Standby Current

• Typical Endurance > 10,000 Cycles

• Single 5V ± 10% Supply

• CMOS and TTL Compatible Inputs and Outputs

• Commercial and Industrial Temperature Ranges

 

Description

 

The AT29C256 is a five-volt-only in-system Flash programmable and erasable read only memory (PEROM). Its 256K of memory is organized as 32,768 words by 8 bits. Manufactured with Atmel’s advanced nonvolatile CMOS technology, the device offers access times to 70 ns with power dissipation of just 275 mW. When the device is deselected, the CMOS standby current is less than 300 µA. The device endurance is such that any sector can typically be written to in excess of 10,000 times.

 

Pin Configurations

 

  Pin Name     Function
  A0 - A14    Addresses
  CE   Chip Enable
  OE   Output Enable
  WE   Write Enable
  I/O0 - I/O7   Data Inputs/Outputs
  NC    No Connect
  DC    Don’t Connect

 

PLCC and LCC Top View

 

Note: PLCC package pins 1 and 17 are DON’T CONNECT.

 

TSOP Top View Type 1

 

 

To allow for simple in-system reprogrammability, the AT29C256 does not require high input voltages for programming. Five-volt-only commands determine the operation of the device. Reading data out of the device is similar to reading from a static RAM. Reprogramming the AT29C256 is performed on a page basis; 64 bytes of data are loaded into the device and then simultaneously programmed. The contents of the entire device may be erased by using a six-byte software code (although erasure before programming is not needed). During a reprogram cycle, the address locations and 64 bytes of data are internally latched, freeing the address and data bus for other operations. Following the initiation of a program cycle, the device will automatically erase the page and then program the latched data using an internal control timer. The end of a program cycle can be detected by DATA polling of I/O7. Once the end of a program cycle has been detected a new access for a read, program or chip erase can begin.

 

Block Diagram

 

Absolute Maximum Ratings*

                                                                                                       

Temperature Under Bias................................ -55°C to +125°C

 

Storage Temperature..................................... -65°C to +150°C

 

All Input Voltages (including NC Pins)

with Respect to Ground ...................................-0.6V to +6.25V

 

All Output Voltages

with Respect to Ground .............................-0.6V to VCC + 0.6V

 

Voltage on OE

with Respect to Ground ...................................-0.6V to +13.5V

                                                                                                           

*NOTICE: Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Related Products
Image Part # Description
AT25128AN-10SI-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

AT25128AN-10SI-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 128Kbit SPI 20 MHz 8-SOIC
AT25160A-10TI-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

AT25160A-10TI-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 16Kbit SPI 20 MHz 8-TSSOP
AT24C64BN-10SU-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

AT24C64BN-10SU-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 64Kbit I²C 400 kHz 900 ns 8-SOIC
AT25020AY1-10YI-1.8 Flash Memory IC NEW AND ORIGINAL STOCK

AT25020AY1-10YI-1.8 Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 2Kbit SPI 20 MHz 8-MAP (3x4.9)
AT25040AY1-10YI-1.8 Flash Memory IC NEW AND ORIGINAL STOCK

AT25040AY1-10YI-1.8 Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 4Kbit SPI 20 MHz 8-MAP (3x4.9)
AT25010AN-10SU-1.8 Flash Memory IC NEW AND ORIGINAL STOCK

AT25010AN-10SU-1.8 Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 1Kbit SPI 20 MHz 8-SOIC
AT25020AY1-10YI-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

AT25020AY1-10YI-2.7 Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 2Kbit SPI 20 MHz 8-MAP (3x4.9)
24LC64-I/P TV Memory IC 64Kb ( 8K X 8 ) I²C 400kHz 900ns 8 PDIP Eeprom Flash Memory

24LC64-I/P TV Memory IC 64Kb ( 8K X 8 ) I²C 400kHz 900ns 8 PDIP Eeprom Flash Memory

EEPROM Memory IC 64Kbit I²C 400 kHz 900 ns 8-PDIP
AT24C512C-SSHD-T Flash Memory IC NEW AND ORIGINAL STOCK

AT24C512C-SSHD-T Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 512Kbit I²C 1 MHz 550 ns 8-SOIC
AT25010N-10SC Flash Memory IC NEW AND ORIGINAL STOCK

AT25010N-10SC Flash Memory IC NEW AND ORIGINAL STOCK

EEPROM Memory IC 1Kbit SPI 3 MHz 8-SOIC
Send RFQ
Stock:
MOQ:
10pcs